Tag: consumables
-
Plasma Consumable Compatibility Chart
Plasma consumable compatibility is determined by torch model, torch series, and the exact stack order of the parts in the torch head. Do not match parts by appearance alone. A tip, shield,…
-
PAPR Filter Replacement Checklist
Use this checklist to decide when a PAPR filter replacement is due and to reduce the chance of restricted airflow during welding. Treat filter condition as a maintenance item, not a guess.…
-
When to Replace Oxy-Fuel Torch Tips
Oxy-fuel torch tips wear over time. A tip that is dirty, distorted, or damaged can cause poor flame shape, unstable cutting, and inconsistent heating. Knowing when to clean and when to replace…
-
Plasma Cut Has Beveled Edge
A beveled edge on a plasma cut usually means the arc is not centered through the kerf. The most common causes are torch angle, travel speed, worn consumables, incorrect standoff, and poor…
-
Plasma Cutter Not Piercing Cleanly
If a plasma cutter is not piercing cleanly, the usual cause is a setup problem rather than a major machine fault. Start with air quality, consumable condition, ground connection, torch angle, and…
-
Exothermic Cutting Rod Will Not Stay Lit
If an exothermic cutting rod will not stay lit, start with oxygen delivery, rod condition, and starting technique. Most ignition problems come from inconsistent gas flow, a worn consumable, or a poor…
-
TIG Torch Gets Too Hot During Welding
TIG Torch Gets Too Hot During Welding If you are dealing with tig torch overheating, treat it as a setup or duty-cycle problem first. Excess heat at the torch can damage the…
-
Why Your MIG Welder Sputters and Pops: Diagnosis and Fix
Your MIG welder sputters, pops, or cuts out mid-weld. The arc is unstable, the weld looks rough, and you’re losing time troubleshooting. This guide walks you through the most common causes—and how…