Welding guides
Parts, troubleshooting, equipment, and life in the trade. Browse by topic or search below.
-
Plasma Torch Retaining Cap Damage Causes: Heat, Double Arcing, Loose Caps, and Wrong Consumable Stack
If a plasma torch retaining cap is melted, cracked, burned, cross-threaded, stuck, discolored, or causing torch-cap faults, stop cutting and inspect the full consumable stack. The retaining cap holds the electrode, swirl…
-
TIG Ceramic Cup Cracking Causes: Thermal Shock, Over-Tightening, Gas Lens Fit, and Torch Heat
If a TIG ceramic cup cracks, breaks in a clean ring, chips at the end, splits at the base, or keeps failing after short welds, do not treat it as a random…
-
TIG Collet Body Overheating Symptoms: Hot Torch Front End, Black Tungsten, Arc Wander, and Gas Lens Damage
If a TIG collet body overheats, the torch front end may run hot, the tungsten may discolor, the arc may wander, the cup may crack, or the electrode may loosen after a…
-
TIG Torch Gas Leak Troubleshooting: Argon Loss, Black Tungsten, Porosity, and Torch Seal Checks
If a TIG torch has a gas leak, the weld may show black tungsten, gray weld color, porosity, sugaring on stainless, unstable starts, or a loud uneven gas hiss even when the…
-
TIG Tungsten Splitting Causes: Cracked Electrodes, Spitting, Balling, and Arc Instability
If TIG tungsten is splitting, cracking lengthwise, spitting small particles into the weld, balling excessively, or breaking down after only a few starts, stop and check heat load, shielding, polarity, tungsten type,…
-
ESAB Aluminum Spool Gun Setup Guide: Rebel Compatibility, Argon, Wire Size, and Feed Checks
Set up an ESAB aluminum spool gun by verifying the machine supports the exact spool gun, connecting the gun fully, using 100% argon shielding gas, installing the correct aluminum contact tip, loading…
-
Lincoln POWER MIG Gas Solenoid Troubleshooting: No Gas, Gas Keeps Flowing, or Weak Shielding Flow
If a Lincoln POWER MIG has no shielding gas at the gun, gas that keeps flowing after trigger release, or weak gas flow even though the cylinder is open, troubleshoot the gas…
-
MIG Gun Cable Overheating Causes: Duty Cycle, Loose Connections, Liner Drag, and Undersized Guns
If a MIG gun cable gets hot enough to soften the jacket, smell burned, heat the handle, discolor the power pin, or make the gun uncomfortable to hold, stop welding and inspect…
-
MIG Wire Feeding at Inconsistent Speed: Causes, Tests, and Feed Path Fixes
If MIG wire feeds at inconsistent speed, surges mid-bead, slows down, slips at the drive rolls, or starts smooth and then stutters, troubleshoot the wire path before replacing the drive motor or…