Welding guides
Parts, troubleshooting, equipment, and life in the trade. Browse by topic or search below.
-
Square Wave 205 TIG Arc Wandering Causes: Tungsten, Gas, Ground, and AC Setup Checks
If a Lincoln Square Wave 205 TIG arc wanders, splits, flutters, or refuses to stay centered on the joint, start with tungsten condition and torch setup before blaming the machine. Arc wandering…
-
Lincoln Square Wave 205 TIG Tungsten Contamination Troubleshooting
If the tungsten on a Lincoln Square Wave 205 turns black, balls unevenly, grows a dirty tip, spits into the puddle, or makes the TIG arc wander, stop and correct contamination before…
-
Why Auto-Darkening Helmets Flicker on Aluminum TIG but Not MIG or Stick
An auto-darkening helmet that behaves normally on MIG or stick but flickers on aluminum TIG is usually not failing in the same way as a helmet that will not darken at all.…
-
Miller 211 PRO MIG Wire Slipping in Drive Rolls: Feed Pressure, Groove, and MDX-100 Checks
If a Miller 211 PRO slips wire in the drive rolls, do not immediately crank down the tension knob. Wire slipping usually means the drive system is fighting drag somewhere else: wrong…
-
Millermatic 211 PRO MIG Gun Trigger Failure Diagnosis: MDX-100 Switch, Cable, and Machine Checks
If a Millermatic 211 PRO does not feed wire when the trigger is pulled, feeds intermittently, welds only when the gun cable is moved, or keeps feeding after the trigger is released,…
-
Millermatic 252 Spool Gun Setup Issues: Spoolmatic 15A/30A Aluminum MIG Troubleshooting
If a Millermatic 252 will not feed aluminum through the spool gun, has no arc, no gas, birdnesting inside the spool gun, burnback at the tip, or welds with heavy black soot,…
-
211 Pro MIG Weld Porosity Troubleshooting: MDX-100 Gas Coverage, Nozzle, and Setup Checks
If a 211 Pro MIG weld has pinholes, worm tracks, black soot, popping starts, or porous spots after grinding, check shielding coverage before changing wire speed or blaming the machine. On the…
-
211 PRO MIG Shielding Gas Flow Problems: MDX-100 Porosity and Gas Coverage Checks
If a 211 PRO MIG welder suddenly makes porous welds, black soot, oxidized beads, popping starts, or welds that look contaminated even on clean steel, check shielding gas flow before changing drive…
-
211 PRO MIG Gun Liner Wear Symptoms: MDX-100 Wire Feed Troubleshooting
If a 211 PRO starts stuttering, burning wire back into the contact tip, birdnesting at the drive rolls, or feeding smoothly only when the gun cable is straight, inspect the MDX-100 gun…
-
Oxylance Sure Cut Lance Kit: Replacement Rods, Wear Parts, and Safety Setup
The Oxylance Sure Cut Lance System Kit is a high-intent replacement and upgrade option for shops that cut seized pins, heavy scrap, cast material, thick plate, stainless, aluminum, or contaminated metal, where…